![]() ![]() The typical way to apply patches to ESXi hosts is by using the VMware vSphere Update Manager. Image Profile Nameįor more information about the individual bulletins, see the Product Patches page and the Resolved Issues section. Application of the general release image profile applies to new bug fixes. VMware patch and update releases contain general and critical image profiles. Upgrading only the ESXi hosts is not supported.īefore an upgrade, always verify in the VMware Product Interoperability Matrix compatible upgrade paths from earlier versions of ESXi, vCenter Server and vSAN to the current version. IMPORTANT: For clusters using VMware vSAN, you must first upgrade the vCenter Server system. This rollup bulletin contains the latest VIBs with all the fixes since the initial release of ESXi 6.7. Virtual Machine Migration or Shutdown Required: Output will show driver version and number of cards.92fb8d22d012c34195a39e6ccca2f123dfaf6db64fafcead131e9d71ccb2b146 Start the nvidia-init service by running the command: /etc/init.d/nvidia-init startĬonfirm driver is updated, running, and seeing the GPUs by running the command: nvidia-smi Install the new VIB: esxcli software vib install -v /path_to_vib/nvidia_vib Remove the VIB by running the command: esxcli software vib remove -n nameofNVIDIAVIB Identify the NVIDIA VIB name by running this command: esxcli software vib list | grep NVIDIA Remove the NVIDIA VMkernel driver by running the command: vmkload_mod -u nvidia Stop the nvidia-init service by running the command: /etc/init.d/nvidia-init stop ![]() When I was running through this the xorg service was already stopped, but I ran the command anyway to make sure: /etc/init.d/xorg stop Once Maintenance Mode is complete SSH into ESXi CLI on your MM host. Use manual DRS to move VMs or manual migrate if needed. Maintenance Mode a host to start rolling through. The full process I ran through to update the VIBs on my hosts The solution I found to bypass the error was to stop the nvidia-init service by running the command: /etc/init.d/nvidia-init stop The error message was: vmkload_mod: Can not remove module nvidia: module symbols in use ![]() When updating NVIDIA VIBs from 430.46 / 431.79 to 440.87 / 443.05 on ESXi 6.7 I ran into an error message and step that was not listed in the VMware documentation. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |